Flushing engine oil system 5 ‑ minute

Means for flushing the lubrication system of diesel and gasoline internal combustion engines of all types of vehicles and stationary installations. Used before replacing engine oil. Thanks to a combination of detergent-dispersant additives, it removes all kinds of deposits and solids insoluble in oil: carbon deposits, sludge, coke, varnish. During the washing process, the oil channels, crankcase, piston rings, hydraulic lifters and other engine components are cleaned.
One bottle of product is enough for an oil system with a volume of up to 6 liters.

For engines of all types.
It removes sludge, lacquer formations, solids insoluble in oil.
For oil systems up to 6 liters.

Application

Warm up the engine to operating temperature.
Switch off the engine, pour the contents of the vial into the oil filler neck. For engines with an oil system volume of less than 3 L, use half the bottle.
Screw on the oil filler cap and start the engine for 5–7 minutes at idle (if the engine oil has not changed for a long time or there are signs of severe contamination of the oil system, it is allowed to increase the cleaning time to 15–20 min).
Stop engine. Observe the precautions to drain the used oil.
Be sure to replace the oil filter. Add fresh engine oil.
Attention! The engine must be idling during cleaning!