The composition reliably eliminates leaks of antifreeze (antifreeze) and prevents their occurrence in the future.

Appointment: for elimination of leaks:

at the place of soldering copper radiators;
at the junction of plastic tanks with an aluminum heat exchanger of modern composite radiators;
through broken radiator tubes (it is advisable to press them with pliers above and below the leak before repair);
through the pump or thermostat gasket (white smudges on the engine);
through radiator pipes and heater tap;
through the heater tap seal (antifreeze flows into the cabin);
from the radiator of the heater (in the cabin there is a smell of antifreeze and windows are sweating).
Action: hardens, only flowing out of the leak, does not clog the radiator tube.

Withstands heat without vaporizing and remaining in the system.
Prevents leaks in the cooling system during subsequent operation of the car.
Compatibility: can be used with all types of antifreeze and antifreeze and water. Safe for aluminum, steel, cast iron, non-ferrous alloys, plastic, rubber.

The use of the drug will not cause difficulties even for novice users - just read the instructions carefully and follow them.

Stop the engine and allow it to cool.
Remove the radiator cap, shake the bottle vigorously and pour the composition into the radiator. If there is no radiator cap, disconnect the hose, fill the composition through the upper radiator pipe and reconnect the hose or fill the composition in the expansion tank, after draining 2-3 liters of coolant.
Bring the coolant level to normal.
Fully open the heater tap, if provided for by design.
Start the engine, warm it up at idle at medium revolutions (2500–3000 rpm) for 5–7 minutes.
Stop and cool the engine.
Add coolant to normal and operate the vehicle as usual.
The packaging is designed to handle a cooling system of up to 17 liters. To obtain the guaranteed effect, it is recommended to pre-flush the cooling system with a “7-minute flush”