RiMET for treatment petrol gasoline engine - 100 ml.

Product description
RiMET - the first Russian remetallizant developed by the Academy of Sciences for the CIP to increase the resource of internal combustion engines. RiMET more than 20 years in the market and gained a reputation as a reliable and trusted drug in hundreds of thousands of car owners in Russia and abroad.RiMET alloy powder comprising ultrafine copper - tin (Cu-Sn) having an average particle size of 2-3 microns. Due to the special treatment the surfactants, the powder particles do not interact with the oil and with each other and almost do not settle.
RiMET recommended for different types of engines of cars, trucks, engines, mobile and stationary power plants of various capacities, compressors and other equipment. Preparations RiMET series compatible and can be used with any type of lubricating oil.
The effect of
- Reduced wear rate of 30-40%;
- Decreases the coefficient of friction of 2-4%;
- Greatly increases turnaround time and overhaul;
- Starting of the engine is facilitated, especially at low temperatures;
- Recovered and leveled compression in the cylinders;
- Increased capacity of up to 3-5%;
- Increased oil pressure;
- Reduced fuel consumption, oil and CO content in the exhaust gases;
- Reduced noise level.

The action of the drug is no more than 600 kilometers and is maintained until the next oil change, but not more than 10-15 thousand. Km.
Mode of application
1. Engine Preparation
- If necessary, rinse the oil system and the crankcase;
- drain the old engine oil;
- replace the fine filter oil;
- if there is a centrifuge to clean her body from deposits and wash it with gasoline or kerosene;
- pour fresh engine oil.

2. Fill the drug
Pour RiMET recommended directly before the trip, either immediately after casting to the engine run at idle for 10-15 minutes for uniform distribution of drug particles throughout the volume of oil.

Gulf more than 1 bottle, do it sequentially: first one, then after 150-200 km of run, the next bottle.

- Before pouring formulation is necessary, without opening the bottle, shake it vigorously for 20-30 seconds;
- Immediately after stirring pour the contents of the cylinder in the engine oil through the oil filler neck;
- Check for sediment on the bottom of the container, which may be insufficient when a strong shaking.It is then necessary to pour a small amount of fresh cylinder engine oil again vigorously shake or stir the contents of the cylinder and pour into a slurry oil.