Thanksgiving - Owl Place Card Holders and Turkey Napkin Rings - Choice of Sizes 3D Printed Plastic Owl Place Card Holder is available in the following sizes: Small: Height 2.5” x Width 1.7” x 1.0” (Height 63mm x Width 43mm x 25mm) Medium: Height 3.0” x Width 2.0” x 1.2” (Height 76mm x Width 52mm x 30mm) Large: Height 3.5” x Width 2.3” x 1.4” (Height 88mm x Width 60mm x 35mm) Extra Large: Height 4.0” x Width 2.7” x 1.6” (Height 101mm x Width 69mm x 41mm) Turkey Napkin Ring is available in the following size: Small (One size) Width 2.0” x 1.5” x 0.39” (51mm x 39mm x 10mm) Color may vary from what is pictured. I DO accept Color requests at no extra charge. I DO NOT accept special requests to alter a model or the cutter (design work). Please note: To insure fulfillment of color request, please message me for availability and confirmation of your color request before making purchase. This item is made to order with a high quality 3D printer in plastic at the time of order. They are made in the order that payment was received (put in a queue). The wait time to print does vary. If you need this item right away, please feel free to request the current queue time before ordering. Normally this is 24 to 36 hours to ship. Due to the build process of 3D printing being built layer by layer, it is normal for slight surface imperfections to occur. All prints are hand smoothed, minimizing these imperfections, prior to shipping to provide the highest detail possible. Shipping and Discounts: All items are set up to automatically discount as follows: Any promotional offers are discounted by using the "Add to Cart "only.To qualify for any discounts, items must be paid together, on the same eCRATER invoice.If paid separately, no discounts will be applied though seller reserves the right to ship together.If there are any questions or concerns about the amount due, please message me before paying so I can address all of your concerns before there is a problem. Buyer assumes responsibility once payment has been made.