Model #: CBC-10 Features:Reduces fine sediment and chlorine taste and odor in residential and commercial drinking waterNominal filtration rating of 1 micronCoconut-based carbon block media with polyolefin pre-filter and polyethylene outer nettingInitial pressure drop of 3.3 psi at a flow rate of 1 gpmTemperature range of 40 to 125 degrees F (4.4 to 51.7 degrees C)Product DescriptionThis Pentek CCBC-10 coconut carbon block filter cartridge reduces fine sediment and chlorine taste and odor in residential and commercial drinking water. It has a nominal (85%) filtration rating of 1 micron. It will reduce free available chlorine (FAC) at 2 parts per million (ppm) by at least 75% in up to 20,000 gallons at a flow rate of 1 gallon per minute (gpm). The cartridge is made of water-washed coconut shell based carbon block media enclosed in a polyolefin wrap pre-filter and polyethylene outer netting. The nitrile butadiene rubber (Buna-N) gaskets seal the cartridge against the housing (sold separately). The filter has an initial pressure drop of 3.3 pounds per square inch (psi) at a recommended flow rate of 1 gpm, and operates over a temperature range of 40 to 125 degrees F (4.4 to 51.7 degrees C). This carbon block filter cartridge meets National Sanitation Foundation/American National Standards Institute (NSF/ANSI) standard 42 for quality assurance, and is for purification of residential and commercial drinking water.SpecificationsNominal filtration rating1 micronInitial pressure drop at 1 gpm3.3 psiChlorine reduction20, 000 gallons at 1 gpmOperating temperature range40 to 125 degrees F (4.4 to 51.7 degrees C)Maximum dimensions (H x W)9-3/4 x 2-7/8 inches (248 x 73 mm)Materials certificationNSF/ANSI standard 42The nominal filtration rating is for a particle removal efficiency of 85%. Chlorine reduction capacity is the minimum total amount of water for which the free available chlorine (FAC) at a concentration of 2 ppm is reduced by at least 75%.Water filters remove undesirable particles, chemicals, and microorganisms from water by means of a semipermeable barrier, adsorption, or biological processes. They are made of densely packed synthetic or natural fibers that trap suspended particles, materials that block microbes or adsorb unwanted chemicals, or substances that cause a chemical change, such as acid neutralization. For most residential, commercial, and industrial applications, water filters are manufactured in the form of replaceable cartridges that fit inside permanent housings. Filtration systems typically consist of a series of two or more types of filters, each designed to remove different contaminants. The performance of filters is measured by the minimum particle size that is blocked, the percentage of particles or microorganisms that are removed, the downstream concentration of unwanted chemicals, the maximum flow rate, and the amount of water that can be filtered before the filter must be replaced. Water filters are used in a wide range of applications, including drinking water purification, swimming pools, industrial processes, and irrigation, among others.