$170.51
Add to Cart
Printrboard
10 available, 3 sold
Details
Shipping: Australia: $72.00 (more destinations)
Condition: Brand new
*The store has not been updated recently. You may want to contact the merchant to confirm the availability of the product.
Fully Assembled, Tested Printrboard Electronics loaded with the Marlin Firmware and LUFA CDC Boot Loader
• Offers Improved production grade by adding heatbed and SD card support , Allegro stepper drivers, Also elimination of the FTDI UART chip
• Printrboard is by far the fastest and most reliable Electronics.
• Printrboard works great with any RepRap: Prusa, Mendel, Printbot, Rapidbot,Orca etc.
Features :
• Atmel AT90USB1286 Microcontroller
• Four integrated Allegro A4982 Stepper
• Four 5V Endstop Connectors Supplied
• OnBoard SD Card Slot
• 2 N-MOSFETs for Extruder and Heatbed control
• 1 N-MOSFET for low power Fan or motor
• Revision D
• Green Power LED
• 4 layer, 2oz Cu PCB with ENIG Finish -- Excellent current handling & thermal dissipation
This Printrboard Electronics Set Includes :
• LUFA CDC Bootloader* and Marlin RC2 firmware Pre-Installed
• 3 Pieces of 3 Pin Molex with Mechanical switch Pre Soldered.
• 2 Pieces of 2 Pin High Temperature Molex (for Thermistor).
• 1 Piece of 2 Pin Molex (for Fan).
• 2 Pieces of 4 Pin High Temperature Molex (for Heaters).
• 1 Piece of Micro USB cable.
• Resistor
All Molex are 600 mm Long
For More information visit WWW.makemendel.com
you can write to us at [email protected]
• Offers Improved production grade by adding heatbed and SD card support , Allegro stepper drivers, Also elimination of the FTDI UART chip
• Printrboard is by far the fastest and most reliable Electronics.
• Printrboard works great with any RepRap: Prusa, Mendel, Printbot, Rapidbot,Orca etc.
Features :
• Atmel AT90USB1286 Microcontroller
• Four integrated Allegro A4982 Stepper
• Four 5V Endstop Connectors Supplied
• OnBoard SD Card Slot
• 2 N-MOSFETs for Extruder and Heatbed control
• 1 N-MOSFET for low power Fan or motor
• Revision D
• Green Power LED
• 4 layer, 2oz Cu PCB with ENIG Finish -- Excellent current handling & thermal dissipation
This Printrboard Electronics Set Includes :
• LUFA CDC Bootloader* and Marlin RC2 firmware Pre-Installed
• 3 Pieces of 3 Pin Molex with Mechanical switch Pre Soldered.
• 2 Pieces of 2 Pin High Temperature Molex (for Thermistor).
• 1 Piece of 2 Pin Molex (for Fan).
• 2 Pieces of 4 Pin High Temperature Molex (for Heaters).
• 1 Piece of Micro USB cable.
• Resistor
All Molex are 600 mm Long
For More information visit WWW.makemendel.com
you can write to us at [email protected]
IN, maharashtra
